V1 Jet-em Manual — Alpha

Keep the heater's power off and open the stop valve. Let water run through the entire system for one minute to flush out any plumbing debris before your first test.

While the heater is operating normally, press the mechanical button located on the front casing.

The Alpha V1 Jet-Em integrates advanced fluid dynamics with high-output mechanical control. Understanding the baseline hardware configuration prevents operational errors and system overloading. Key Technical Specifications 15 kW / 20 HP equivalent Maximum Operating Pressure: 350 bar (5,076 PSI) Flow Rate: 12–18 Liters per minute (Lpm) Voltage Input: 400V AC, 3-Phase, 50/60 Hz Control Interface: 7-inch LED Digital HMI Touchscreen Dry Weight: 142 kg (313 lbs) Primary Components alpha v1 jet-em manual

Connect a minimum 3/4-inch reinforced supply line to the low-pressure inlet. The inlet pressure must remain stable between 2 and 5 bar.

If the Line Fault Detector is Red, contact a qualified electrician immediately. Water Temperature Fluctuates Sudden water shut-off Keep the heater's power off and open the stop valve

Provides thermal conditioning from ambient temperatures up to 140°C to reduce fluid viscosity. 2. Unpacking and Hardware Installation

attempt to patch or repair a leaking high-pressure hose. Damaged hoses must be replaced immediately. The Alpha V1 Jet-Em integrates advanced fluid dynamics

For more information about the Alpha V1 Jet-EM device or to access additional resources, please visit our website or contact our customer support team. We are committed to providing users with the support and resources they need to get the most out of their device.