Switches do not have polarity. It does not matter which way the text faces. 3. Connect the Reset Switch (Reset SW)
Note: Exact labeling and layout can vary by BIOS/board revision and by Foxconn OEM partners; treat this as the common mapping for boards in this series.
If you have landed on this page, chances are you are staring at a bare Foxconn N15235 motherboard pulled from an Acer Aspire, a Packard Bell, or an old office PC. You see a cluster of small, metal pins in the bottom-right corner, and you have no idea which wire goes where. You are not alone.
Pin 1 is the top-left pin (next to the missing pin gap). Pins increase left to right on the top row, then left to right on the bottom row. foxconn n15235 motherboard front panel connectors
| Pin | Signal | Function | | :--- | :--- | :--- | | | +HDD_LED (Pin 1) | Hard Drive LED (+) | | 2 | +PLED (Pin 2) | Power LED (+) | | 3 | -HDD_LED (Pin 3) | Hard Drive LED (-) | | 4 | -PLED (Pin 4) | Power LED (-) | | 5 | +RESET_SW (Pin 5) | Reset Switch (+) | | 6 | +PWR_SW (Pin 6) | Power Switch (+) | | 7 | -RESET_SW (Pin 7) | Reset Switch (-) | | 8 | -PWR_SW (Pin 8) | Power Switch (-) | | 9 | Not Connected (Pin 9) | Reserved / No Connection | | 10 | No Pin (Key) (Pin 10) | Key pin for connector alignment |
If your computer fails to power on after wiring, double-check that the Power Switch (PWR_SW) connector is fully seated on pins 6 and 8 and hasn't accidentally slipped onto adjacent pins. To help troubleshoot your specific system setup, tell me:
Orientation MATTERS. Connect the colored or marked positive wire ( ) to Pin 1, and the white or black negative wire ( −negative Switches do not have polarity
To wire your case correctly, match the small plastic connectors from your PC case to the correct pairs of pins on the motherboard. 1. Power Switch (PW_SW / PWR_SW)
The header consists of two rows. The top row contains 5 pins; the bottom row contains 4 pins.
Controls the light on the outside of your case that shows if the computer is turned on. Connect the Reset Switch (Reset SW) Note: Exact
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
Look for a 10-pin header labeled F_AUDIO . The pins are usually MIC , GND , LINE OUT , and PRESENCE . Conclusion
control the critical interface between your computer case and the motherboard hardware, including the power button, reset switch, hard drive activity light, and power LED. Connecting these pins properly is essential to make your computer turn on and functional.
As Leo carefully slid the connectors onto the pins, he kept these tips in mind from expert guides : Explaining PC Front Panel Connectors
The Power Switch and Reset Switch act as momentary bridges. When you press the button, it momentarily connects the two pins together to signal the motherboard. Because it just creates a temporary short circuit, it does not matter which wire goes to which pin. Connect the to Pins 6 & 8 in any direction. Connect the Reset Switch to Pins 5 & 7 in any direction. Troubleshooting Tips