Gorenje Wa 50050 Manual [work] Jun 2026

This is the most crucial step . The machine is secured for transport. If you run it with bolts in place, it will cause severe damage. Use the provided wrench to remove the rods.

| Programme | Max Load | Temp Range | Description | |-----------|----------|-------------|-------------| | Cotton / White | 5 kg | Cold–90°C | Heavy soil, long wash, high rinses | | Cotton / Coloured | 5 kg | Cold–60°C | Normal soil, reduced mechanical action | | Synthetics | 2.5 kg | Cold–60°C | Gentler wash cycle | | Delicates | 2 kg | Cold–40°C | Low movement, short programme | | Wool / Hand Wash | 1.5 kg | Cold–30°C | Very gentle, intermittent rotation | | Quick / Rapid 30’ | 2 kg | Cold–40°C | For lightly worn, small load | | Rinse + Spin | 5 kg | – | Separate rinse cycle with spin | | Drain | – | – | Only pumps out water | | Spin | 5 kg | – | Extra spin only |

Check if the water tap is fully open. Inspect the inlet hose for kinks or a clogged mesh filter. Water draining failure

Choosing the right program is crucial for fabric care. Here is the program list from the : Gorenje Wa 50050 Manual

Connect the drain hose to a sink or standpipe, ensuring the end of the drain hose is at a height of 60–100 cm. 3. Getting to Know Your Gorenje WA 50050 The control panel is designed for simplicity.

| | Possible Cause / Solution | | :--- | :--- | | Machine won't start | Check if the plug is in the socket; check if the door is closed properly; check if the Start button was pressed. | | Water not draining / Error F3/F4 | Check if the drain hose is kinked; clean the pump filter (see Maintenance). | | Vibration/Noise | Check if transit bolts were removed; ensure the machine is level; check for loose items (coins) in the drum. | | Water on floor | Check the condition of the inlet hose; check if the door seal is damaged; check if the drain hose is leaking. | | Door won't open | The water level is too high or the drum is moving. Wait for the "Door Lock" light to turn off. |

The is a dependable workhorse when used correctly. While the original manual provides the legal and technical specifics, this guide has condensed the most practical information—from installation and program selection to error fixing and cleaning. This is the most crucial step

Designed for blended fabrics, polyester, and delicate shirts. Best washed at 40°C or 60°C.

Pull the drawer completely out by pressing the release lever inside. Rinse under warm water to remove crusty detergent buildup.

Before plugging in the machine, you must remove the transport protection blocks. Operating the machine with transit bolts attached will cause severe damage to the drum and interior motor components. Locate the bolts on the rear panel of the washing machine. Unscrew the bolts using a spanner. Remove the plastic spacers. Use the provided wrench to remove the rods

These videos demonstrate the Gorenje WA 50050 in action, including different cycle starts and internal components: Gorenje WA50050: Quick 40 (start of wash) 6K views · 7 years ago YouTube · GodDay b Gorenje WA50050: Cottons 95 (wash, rinse and some spins) 30K views · 7 years ago YouTube · GodDay b Gorenje WA50050: Wash, Rinse & Unbalanced spin 5K views · 7 years ago YouTube · GodDay b Gorenje Washing Machine Error Codes | PDF - Scribd

Responsible for removing water. A common compatible part is the Askoll M108 25W pump Carbon Brushes: Worn brushes can cause motor failure or "no spin" issues. Pump Filter:

Check for a clogged pump filter (see step 5). Ensure the drain hose is not blocked or positioned higher than 100 cm from the ground. Error 3 (F3): Heating Fault

Verify that the water inlet valve behind the machine is fully open. Water Is Not Draining