Proteus 8 Professional Tutorial

Connect an external LED and a 220-ohm resistor to digital of the Arduino.

Choose your trace width from the selector (e.g., T20 for standard signals, T40 or higher for power lines).

Click the icon on the left toolbar (it looks like an operational amplifier symbol). proteus 8 professional tutorial

Click on a component pad (highlighted by the ratsnest) and follow the guide wire to the destination pad. Click to lock down corners. Standard design practice requires using 45-degree angles rather than sharp 90-degree corners. Method B: Automatic Routing (Auto-Router) Click in the top menu bar, then select Auto-Router .

Adjust the timebase and voltage knobs on the pop-up panel to clearly see the square wave pulsing across the screen. 5. Microcontroller (MCU) and Firmware Simulation Connect an external LED and a 220-ohm resistor

To measure exact voltages and currents at specific nodes.

Connect channel A of the oscilloscope to the output pin (Pin 3) of the 555 timer. Click on a component pad (highlighted by the

When picking components, ensure they have a footprint preview in the lower-right corner of the library window.

Select the NE555 from your device list and click once in the blue workspace box to place it.