Siemens.mc.drives.acx.model.configuration Data.package !new! Jun 2026
Search for "SINAMICS MC Toolbox V17" (or the version corresponding to your TIA Portal V17/V18/V19).
The error (or similar "PackageContainer") typically appears when you try to open a TIA Portal project that was created with a version of SINUMERIK MC or Startdrive that is not currently installed on your computer.
"axisId":"AX1", "motor": "type":"PMSM", "ratedTorqueNm":12.5 , "encoder": "type":"HTL", "resolution":2048, "offset":12.3 , "controlParams": "mode":"position", "sampleTimeMs":1, "pid": "P":120, "I":15, "D":0.2 , "limits": "posMin":-100000, "posMax":100000, "torqueLimit":15 Siemens.mc.drives.acx.model.configuration Data.package
: The package helps define how the drive communicates with a SIMATIC S7-1500 PLC , using standard or Siemens-specific telegrams like Telegram 103.
Verify that your Startdrive installation perfectly mirrors the TIA Portal framework version. If you are running TIA Portal V19, you must download and install (either Basic or Advanced). Required Software - SiePortal - Siemens Search for "SINAMICS MC Toolbox V17" (or the
Therefore, the keyword is not a standalone file but the that provides a specific configuration model. When TIA Portal reports this as a missing requirement, it is not a faulty error message but an accurate dependency check.
The nomenclature of this package defines its strict functional boundaries within the Siemens automation ecosystem: When TIA Portal reports this as a missing
DataPackage driveCfg = ACXModel.load("drive_config.acx"); Parameter p1120 = driveCfg.getParameter("p1120"); // ramp-up time p1120.setValue(2.5f); driveCfg.validate(); driveCfg.exportToDevice(ipAddress);
During an interrupted software update, the data package files can become corrupted. A clean reinstall of the Startdrive or Edge application block is usually required.
It is primarily associated with SINAMICS MC (Motion Control) drives.
