Before installation, ensure your kitchen setup matches the requirements of the unit:
Cycle the preheat function off and on. Purge air bubbles out by turning on the hot water tap furthest away from the main heater unit. Power Failure / Disconnection
: If a fault occurs, closing and re-opening the tap may clear the code. If it persists, turn off the main power supply for 10 seconds before restarting. www.towngasappliance.com tgc bc-90-1h manual
A red light illuminates when the temperature is set to 50°C or higher as a warning to prevent scalding.
: Used to access and save temperature configurations. Before installation, ensure your kitchen setup matches the
A: Yes, if you wire them in parallel (positive to positive, negative to negative). The manual notes that the total amp-hour (Ah) capacity should not exceed 300Ah for optimal charging.
: Grants or transfers operating control between different wired locations. If it persists, turn off the main power
: If the device is no longer supported or you're looking to create a guide for personal use or for a community:
: To maintain cooling efficiency, the manual requires a minimum of 50mm-100mm
This section details how an engineer integrates the BC-90-1H into a full machine assembly.