Place the base plate flat against your intended mounting surface (wall, brickwork, or pillar).
Connect the leads of the included NTC thermistor or PT100 probe. Sensor wires do not have polarity, so either wire can go into either terminal.
: Connects directly to the Challenger RS-485 LAN .
The includes a navigation flowchart. Typically: ts1162 installation manual
| Parameter | Day (06:00–22:00) | Night (22:00–06:00) | |-----------|-------------------|----------------------| | Heat Setpoint | 74°F | 67°F | | Cool Setpoint | 76°F | 69°F | | Hysteresis | ±1°F | ±1.5°F |
Use the provided template to mark mounting holes and cable entry points.
: Use 2-pair twisted, shielded data cable (e.g., Belden 8723) for optimal data transmission across the RS-485 network. Tools Needed : Phillips head screwdriver Precision flat-head screwdriver (for terminal blocks) Wire strippers Digital multimeter (for voltage verification) Mechanical Mounting Steps The IP67 rating allows the Place the base plate flat against your intended
Access the configuration menu via the onboard display or the connected software utility.
A correct installation ensures crisp documents, vibrant photos, and reliable scanning for years. Take your time, follow each step in sequence, and do not hesitate to use the troubleshooting section if something goes wrong.
Guidance on terminating the RS-485 data cable shield to avoid electrical noise. Accessibility: 6/10 : Connects directly to the Challenger RS-485 LAN
: Hook the top of the body onto the base tabs and secure with the bottom retaining screws. 3. Support and Documentation
Using DIP switches 1 through 4 to set the unique LAN address (1–16).
Input your specific operational parameters (baud rate, IP address, or setpoints) as dictated by your project requirements. 5. Troubleshooting Common Issues