Caselabs Sma8 Manual -

Route your EPS, ATX, and PCIe cables through the dedicated grommets.

The SMA8 uses a proprietary front panel PCB.

The Ultimate CaseLabs SMA8 Manual: Assembly, Customization, and Documentation Guide

Thread the brass standoffs into the holes matching your motherboard form factor (e.g., ATX or E-ATX). caselabs sma8 manual

Install your CPU, RAM, and primary M.2 drives before sliding the tray into the case to avoid clearance issues with large water-cooling blocks.

The SMA8 was designed for massive cooling. The top and bottom chambers accept "Flex-Bays."

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Route your EPS, ATX, and PCIe cables through

Slide the tray smoothly from the back of the case forward along the tracks.

Drop the entire assembly back into the top cavity and secure the bracket screws. Lower Chamber Installation

The SMA8 features a removable motherboard tray. The manual implies you should install the tray before the outer panels. Slide the tray into the center channel and secure it via the thumbscrews on the rear of the chassis. Install your CPU, RAM, and primary M

Install your Power Supply Unit (PSU) in the lower basement compartment. The SMA8 features adjustable PSU mounts, allowing you to accommodate massive, high-wattage power supplies or even dual-PSU setups. Mastering SMA8 Water-Cooling & Radiator Configurations

Motherboard flips upside down, moving to the left side of the case. Assembly and Installation Lay the motherboard tray flat on your table.

Install the bottom radiator mount and the mid-plate (the divider between the motherboard chamber and the PSU/radiator chamber). Install PSU: Mount the power supply in the lower chamber. Phase 2: The Motherboard Chamber