The auxiliary send allows you to send a portion of the audio signal to an external processor or effect. To use the auxiliary send:

Do not leave the mixer plugged into a fast charger indefinitely. Charge the device fully, then use it wirelessly to preserve the lifespan of the internal lithium-ion battery.

Use the high, mid, and low knobs to sculpt the tone of your voice or instrument.

To make the most of your purchase, it's important to know the correct disposal method for the device at the end of its life and to understand its warranty coverage.

In your sound settings, set it as the default recording and playback device. Common Troubleshooting : Ensure the Input Selector

An input port to feed background music from a phone, tablet, or PC into the mixer.

4 mono MIC/LINE combo jacks (XLR + 6.35mm) and 1 stereo channel (Channels 5/6). Built-in Sound Card:

| Issue | Possible Cause | Solution | | :--- | :--- | :--- | | | Master or channel volume is down; cables are not connected properly. | Check all fader and gain settings; verify cable connections and try different cables. | | Distorted Sound | Input gain (trim) is set too high. | Lower the GAIN control on the appropriate channel. | | Hum or Buzzing Noise | Ground loop issue; faulty cable. | Use balanced cables; ensure all equipment is on the same power strip; try a ground lift adapter. | | Microphone Not Working | Phantom power not engaged (for condensers); channel muted. | Turn on the +48V phantom power switch; check if the channel has a mute button and ensure it is disengaged. | | Headphone Output Not Working | Incorrect driver in computer OS; volume too low. | Check your computer's audio settings and ensure the correct playback device is selected. |

Adjusts the output level of the headphone jacks without affecting the broadcast or recording volume.

Single-A Affiliate

The Official Site of the Dunedin Blue Jays Dunedin Blue Jays

Drembo M6 Mixer User Manual ~upd~ 💫

The auxiliary send allows you to send a portion of the audio signal to an external processor or effect. To use the auxiliary send:

Do not leave the mixer plugged into a fast charger indefinitely. Charge the device fully, then use it wirelessly to preserve the lifespan of the internal lithium-ion battery.

Use the high, mid, and low knobs to sculpt the tone of your voice or instrument. drembo m6 mixer user manual

To make the most of your purchase, it's important to know the correct disposal method for the device at the end of its life and to understand its warranty coverage.

In your sound settings, set it as the default recording and playback device. Common Troubleshooting : Ensure the Input Selector The auxiliary send allows you to send a

An input port to feed background music from a phone, tablet, or PC into the mixer.

4 mono MIC/LINE combo jacks (XLR + 6.35mm) and 1 stereo channel (Channels 5/6). Built-in Sound Card: Use the high, mid, and low knobs to

| Issue | Possible Cause | Solution | | :--- | :--- | :--- | | | Master or channel volume is down; cables are not connected properly. | Check all fader and gain settings; verify cable connections and try different cables. | | Distorted Sound | Input gain (trim) is set too high. | Lower the GAIN control on the appropriate channel. | | Hum or Buzzing Noise | Ground loop issue; faulty cable. | Use balanced cables; ensure all equipment is on the same power strip; try a ground lift adapter. | | Microphone Not Working | Phantom power not engaged (for condensers); channel muted. | Turn on the +48V phantom power switch; check if the channel has a mute button and ensure it is disengaged. | | Headphone Output Not Working | Incorrect driver in computer OS; volume too low. | Check your computer's audio settings and ensure the correct playback device is selected. |

Adjusts the output level of the headphone jacks without affecting the broadcast or recording volume.